The Winslow pellet insert, by the makers of the Whitfield pellet stove, is a handsome bay window style which can be adapted to smaller fireplaces by adjusting the hopper size and using a surround kit which moves the fire out into the room by three inches.It has a robust heat exchanger with high capacity to transfer heat to the home.
The fire will cycle to a high combustion rate once an hour which blows debris away from the burn pot and reduces the frequency the burn pot needs to be scraped.
Surge Protector RecommendedIf you are unsure of the meanings of the terms in the pellet stove review below,or their implications, please go to the Pellet Stove Reviews page for an explanation.
Heating Area 2,000 sq.ft.
Max. Heat Output 37,800btu.
Automatic Ignition Yes
Manual Ignition If needed
Hopper Capacity 55lbs., or can have a smaller 40lb. hopper if fireplace space is limited.
Burn time 30hrs. with 55lb. hopper, or 22 hrs. with 40lb. hopper
Fuel Type Premium or standard wood pellets. Or 50% corn / pellet mix.
Glass Air Wash Yes
Built in Blower Yes
Convection Blower Capacity 150cfm.
Thermostat Compatible Yes
E.P.A. Approved Yes
Height Front: 23.4" Rear: 19"
Depth Into fireplace: 15.25" Out of fireplace: 14.4"
Min. Fireplace Size
Height: 22.5" with full size hopper, 19" with reduced hopper.
Width: 36", or 32" with deep surround kit.
Depth: 15.5", or 12.5" using deep surround kit.
Insert Surround Dimensions
29" by 41"
29" by 48"
33" by 41"
33" by 48"
Or 29" by 41" three inch deep surround which allows the insert to be fitted to narrower and shallower fireplaces.
Window Size 18" by 10"
Flue Vent Size 3"
Top Vent No
Rear Vent Yes
Rear Vent Height 8", vertical facing, adaptable to horizontal vent, height 4.75"
Exhaust Temperature Sensor No
Low Draft Shutdown Yes
Construction Type Yes
Automatic Shutdown and Re-ignitionYes
Warranty 20 year limited lifetime. Applies to original owner and installation address and covers the body, heat exchange tubes and glass, (thermal breakage).
Burn pot: 5 years
Electronic components and grate: 2 years
Front Support Kit
Cleaning the flue passageways and emptying the ash pan of the winslow pellet insert is not as easy as with the freestanding stove.
There is a convenient ash trap with a hinged lid at the base of the flue.
The burn pot and its air holes should be cleaned after burning 200lbs. of pellets.
The ash pan should be emptied after burning 1,000lbs. of pellets.
The heat exchanger should be cleaned once a week using the built in scrapers.
The flue passageways in the stove should be cleaned after burning 1,000lbs. of pellets.
The combustion blower, convection blower, air intakes and the proof of fire switch should be cleaned after burning 2,000lbs. of pellets.
The door and window gaskets should be inspected once a year, and the flue checked and cleaned if necessary.
If you would like to leave a review of the Country Collection Winslow pellet insert, please use the form on the contact page.